MRV Communications AE092FCAKA Especificações descarregar pdf (Página 59)

451-0308

Cabling the LX Series

Ordering and Installing the Inlet Connector Lock

You can use an inlet connector lock to lock the AC power cord to the LX

Series unit. MRV Communications does not supply this lock. You can order

the connector lock (part number 85910020) from Panel Components

Corporation. The web address at which you can order the connector lock is:

www.panelcomponents.com/first.html. See Figure 21 for installation

instructions.

Figure 21 - Installing the Inlet Connector Lock

Connecting to the Diagnostic Port (Port 0)

NOTE: Display problems may occur during bootup when you attach a

VT420 terminal to the DIAG port (port 0) and the VT420 display

setup is configured to Smooth-2 Scroll. To avoid this, change

the VT420 scroll setting to Jump Scroll.

Connect the provided serial port cable to the DIAG connector (port 0), and

the other end to your terminal. You can use this direct connect serial link

to send commands to the boot loader and diagnostics. This port is used to

log system messages during bootup. You can also use port 0 to manage and

configure the LX once the unit completes the bootstrap process.

90-250VAC

1.0A 50/60Hz

Insert two 4-40 x

1/4” Philips screws

here. Do not

tighten.

Slide the connector

lock ears under the

screw heads.

Tighten the screws.

Plu

in the power cord

(not shown).

hten the screw

beneath the connector

lock.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 68 69

Sem comentários

MRV Communications AE092FCAKA Especificações Página 59