MRV Communications AE092FCAKA Especificações descarregar pdf (Página 33)

451-0308

Installing the LX Series

• To use the CLI, refer to Figure 16 for the CLI tree structure and to the

LX-Series Commands Reference Guide for information on specific

commands.

• To use Telnet, refer to “Connecting to the LX Series via Telnet or SSH”

on page 39.

• To use the web browser, refer to “Accessing and Configuring the

Graphical User Interface (GUI)” on page 33.

Assigning an IP Address via the Network

The LX is an intelligent unit; if you are running DHCP, BOOTP, or RARP the

LX obtains its own IP information automatically while it boots.

Once the unit has been assigned an IP address from your network, you can

configure the unit.

• To use the CLI, refer to Figure 16 for the CLI tree structure and to the

LX-Series Commands Reference Guide for information on specific

commands.

• To use Telnet, refer to “Connecting to the LX Series via Telnet or SSH” on

page 39.

• To use the web browser, refer to “Accessing and Configuring the

Graphical User Interface (GUI)” on page 33.

Accessing and Configuring the Graphical User Interface

(GUI)

This section describes how to access and configure the LX GUI. To perform

this procedure, you need a PC with Java Runtime Environment (JRE) 1.4 or

later installed.

NOTE: For optimum GUI performance, MRV Communications recommends

that your PC run at 500 Mhz or better. The minimum requirement for

desktop color settings is 256.

To access the GUI, do the following:

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 68 69

Sem comentários

MRV Communications AE092FCAKA Especificações Página 33