MRV Communications AE092FCAKA Especificações descarregar pdf (Página 25)

451-0308

Installing the LX Series

Cable Connections

This section explains the cable connections for the LX unit.

Connect the Power Cable

Connect the supplied power cable to the rear of the LX unit and plug the

other end into a 3-prong wall outlet.

Connecting the Ethernet Interface

NOTE: This port is set to auto negotiation by default. You can manually

configure the port speed and duplex if you want. Refer to the LX-

Series Commands Reference Guide for further details.

Connect a cable (category 3 for 10 Mbps operation, category 5 for 10/100

Mbps operation) to the 10/100 connector on the rear of the LX Series (see

Figure 5) and the other end to your network. The LINK LED comes on

steady green if the cable is properly connected.

Connect Serial Device Cables

Connect the serial device cables to the 8-pin RJ-45 jacks on the rear of the

unit.

NOTE: LX Series serial ports provide concurrent support for RTS/CTS

flow control and modem control. Refer to Appendix A and Appendix

C for further information.

Connecting Your Management Station

Connect the management station to the DIAG port (port 0) using the

connector and cable you received with the LX unit. Refer to “Connecting to the

Diagnostic Port (Port 0)” in Appendix C for more information on DIAG port

connections.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 68 69

Sem comentários

MRV Communications AE092FCAKA Especificações Página 25